#How to replace fuel pump 2003 ford taurus install#

#How to replace fuel pump 2003 ford taurus install#

Install the new fuel pump on the module using the slip joint pliers and screwdriver. Remove the old fuel pump from the module using slip joint pliers and a screwdriver. Then, carefully lift and remove the module from the tank.

Turn the fuel pump module counterclockwise by hand to disengage the module from its mounting flange. Unscrew the fuel pump module retaining ring using tool number 310-D006 or a suitable retaining ring remover. Unfasten the two fuel tank support straps using a ratchet, ratchet extension and socket.Ĭlean the top of the fuel pump module using a wire brush and rag to prevent dirt and debris from falling into the fuel tank after you remove the pump module. Place a wooden block between the tank and floor jack to prevent damage to the tank. Support the fuel tank with the floor jack. Unplug the fuel pump electrical connector.ĭisconnect the fuel filter inlet tube from the filter by hand. If necessary, label each connector for easy reassembly.

Raise the rear of your Taurus using a floor jack and support it on two jack stands.ĭisconnect the three quick-connect couplings from the tubes at the tank by hand. Use a hand siphon pump and a suitable container. Turn the ignition key to the 'Off' position.ĭisconnect the negative (black) battery cable using a wrench.ĭrain the fuel from the fuel tank, if necessary, down to 1/4 tank or less. Start the engine and allow it to idle until it stalls.Ĭrank the engine for five seconds to finish relieving the fuel system pressure.